D-Link DHP-W306AV User Manual

29D-Link DHP-W306AV User Manual
Section 3 - Configuration
LAN Connection Type:
IP Address:
Subnet Mask:
Default Gateway:
Device Name:
Select Static IP from the drop-down menu.
Enter the IP address of the access point. The
default IP address is 192.168.0.50. If you
change the IP address, once you click ,
you will need to enter the new IP address in
your browser to return to the conguration
utility.
Enter the Subnet Mask.
Enter the Gateway. This is usually the LAN or
internal IP address of your router.
Enter the Device Name of the AP. It is
recommended that you change the Device
Name if there is more than one D-Link
device within the subnet. You can enter
the device name of the AP into your web
browser to access it instead of IP address
for conguration. If you are using the device
name to connect, make sure that your PC and
your DHP-W306AV are on the same network.
LAN Setup - Static IP
Select  to manually enter the IP address, subnet mask, and default gateway addresses.

D-Link DHP-W306AV Specifications

Power

power input	240 V AC, 50/60 Hz
power saving mode	supported

Operating Environment

operating temperature	0º to 40ºC (30º to 104ºF)
operating humidity	10% to 95% non-condensing

Data Transmission

powerline data rate	200 Mbps (PHY rate)
ethernet data rate	10/100 Mbps (autonegotiation)
wireless data rate	up to 300 Mbps

Frequency and Modulation

powerline frequency band	2 MHz to 30 MHz
wireless frequency range	2.4 GHz to 2.497 GHz
powerline modulation scheme	OFDM Symbol Modulation

Weight and Dimensions

dimensions	105 x 70 x 52 mm (4.1 x 2.8 x 2.0 inches)
weight	208 g (0.46 lb)