D-Link DHP-W306AV User Manual

46D-Link DHP-W306AV User Manual
Section 4 - Security
Configure WPA/WPA2 Personal
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the access point (192.168.0.50).
Click on Setup and then click Wireless Settings on the left
side.
2. Next to  , select   
, , or 
.
3. Next to , select , , or .
4. Next to , select .
5. Next to , enter a key. The key is entered as a passphrase in ASCII format at both ends of the wireless
connection. The passphrase must be between 8-63 characters.
6. Click  at the top of the window to save your settings. If you are conguring the access point with a
wireless adapter, you will lose connectivity until you enable WPA-PSK on your adapter and enter the same passphrase
as you did on the access point.

D-Link DHP-W306AV Specifications

Power

power input	240 V AC, 50/60 Hz
power saving mode	supported

Operating Environment

operating temperature	0º to 40ºC (30º to 104ºF)
operating humidity	10% to 95% non-condensing

Data Transmission

powerline data rate	200 Mbps (PHY rate)
ethernet data rate	10/100 Mbps (autonegotiation)
wireless data rate	up to 300 Mbps

Frequency and Modulation

powerline frequency band	2 MHz to 30 MHz
wireless frequency range	2.4 GHz to 2.497 GHz
powerline modulation scheme	OFDM Symbol Modulation

Weight and Dimensions

dimensions	105 x 70 x 52 mm (4.1 x 2.8 x 2.0 inches)
weight	208 g (0.46 lb)