D-Link DHP-W306AV User Manual

9D-Link DHP-W306AV User Manual
Section 1 - Product Overview
Hardware Overview
Side

Push this button to establish a
secure powerline network with
other Powerline AV devices.

Press to start the WPS process. You
will have 120 seconds to start the WPS
process on another wireless device.

When enabling WPS, the light will blink
during broadcast. Once connected,
the LED will remain lit 5 seconds and
then will turn off. The LED will start
blinking after the Encryption button
is pushed. The LED will turn off once
the Powerline AV is connected to a
Powerline network.

Press and hold to reset the
device back to the factory
default settings.

D-Link DHP-W306AV Specifications

Power

power input	240 V AC, 50/60 Hz
power saving mode	supported

Operating Environment

operating temperature	0º to 40ºC (30º to 104ºF)
operating humidity	10% to 95% non-condensing

Data Transmission

powerline data rate	200 Mbps (PHY rate)
ethernet data rate	10/100 Mbps (autonegotiation)
wireless data rate	up to 300 Mbps

Frequency and Modulation

powerline frequency band	2 MHz to 30 MHz
wireless frequency range	2.4 GHz to 2.497 GHz
powerline modulation scheme	OFDM Symbol Modulation

Weight and Dimensions

dimensions	105 x 70 x 52 mm (4.1 x 2.8 x 2.0 inches)
weight	208 g (0.46 lb)