Virtual Server Settings
This allows you to enable and disable NAT rules on the DWR-956M.
Enable: Whether to enable or disable the NAT rule. Tick this to enable the
NAT rule. The default is un-ticked.
Description: The description for the NAT rule.
Remote IP Address: The source address for the NAT rule. Leave this blank to
accept any addresses.
Network Mask: The network mask for the NAT rule. Leave this blank to
accept any network mask.
Protocol: The protocol for the NAT rule. This can be TCP, UDP or TCP/UDP.
External Port: The external port to NAT to/from. This can be a range or a
single port.
Internal Port: The internal port to NAT to/from.
Internal IP Address: The internal IP address for the NAT rule.
NAT Loopback: Permits the access of a service via the public IP address from inside the local network.
Tick to enable.
Click Back to go back to the previous page, click Apply to apply the settings and click Refresh to refresh the page.
To Next Page
Loading...
Need help?
General
