•
[Hand on] - [Off] - [Auto on]
•
Reset
•
Coasting stop inverse
•
Reverse
•
Set-up select lsb - Set-up select msb
•
Stop command from serial communication
•
Quick stop
•
DC brake
[Off] stops the connected motor. The key can be selected as
Enable [1] or Disable [0] via 0-41 [Off] Key on LCP.
If no external stop function is selected and the [Off] key is
inactive, the motor can be stopped by disconnecting the
voltage.
[Auto on] enables the adjustable frequency drive to be
controlled via the control terminals and/or serial communi-
cation. When a start signal is applied on the control terminals
and/or the bus, the adjustable frequency drive will start. The
key can be selected as Enable [1] or Disable [0] via 0-42 [Auto
on] Key on LCP.
NOTE!
An active HAND-OFF-AUTO signal via the digital inputs has
higher priority than the control keys [Hand on] [Auto on].
[Reset] is used for resetting the adjustable frequency drive
after an alarm (trip). It can be selected as Enable [1] or
Disable [0] via 0-43 [Reset] Key on LCP.
2.1.19 Initialization to Default Settings
Initialize the adjustable frequency drive to default settings in
two ways:
Recommended initialization (via 14-22 Operation Mode)
1. Select 14-22 Operation Mode
2. Press [OK]
3. Select “Initialization”
4. Press [OK]
5. Cut off the line power supply and wait until the display turns
off.
6. Reconnect the line power supply - the adjustable frequency
drive is now reset.
14-22 Operation Mode initializes all except:
14-50 RFI 1
8-30 Protocol
8-31 Address
8-32 FC Port Baud Rate
8-35 Minimum Response Delay
8-36 Max Response Delay
8-37 Max Inter-Char Delay
15-00 Operating Hours to 15-05 Over Volts
15-20 Historic Log: Event to 15-22 Historic Log: Time
15-30 Fault Log: Error Code to 15-32 Alarm Log: Time
Manual initialization
1. Disconnect from the line power and wait until the display
turns off.
2a. Press [Status] - [Main Menu] - [OK] at the same time during
power-up for LCP 102, Graphical Display
2b. Press [Menu] while powering up for LCP 101, Numerical
Display
3. Release the keys after 5 s.
4. The adjustable frequency drive is now programmed
according to default settings.
This procedure initializes all except:
15-00 Operating Hours
15-03 Power-ups
15-04 Over Temps
15-05 Over Volts
NOTE!
When you carry out manual initialization, you also reset serial
communication, RFI filter settings (14-50 RFI 1) and fault log
settings.
How to Program FC 300 Programming Guide
MG.33.MA.22 - VLT
®
is a registered Danfoss trademark 2-11
2
To Next Page
Loading...
Need help?
General