Danfoss FC 300 Series User Manual

1 Introduction
Programming Guide
Software version: 6.2x
This Programming Guide can be used for all FC 300 adjustable
frequency drives with software version 6.2x.
The software version number can be seen from 15-43 Software
Version.
1.1.1 Approvals
1.1.2 Symbols
Symbols used in this guide.
NOTE!
Indicates something to be noted by the reader.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury or
equipment damage.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
*
Indicates default setting
1.1.3 Abbreviations
Alternating current AC
American wire gauge AWG
Ampere/AMP A
Automatic Motor Adaptation AMA
Current limit I
LIM
Degrees Celsius
°C
Direct current DC
Drive Dependent D-TYPE
Electro Magnetic Compatibility EMC
Electronic Thermal Relay ETR
Adjustable Frequency Drive FC
Gram g
Hertz Hz
Kilohertz kHz
Local Control Panel LCP
Meter m
Millihenry Inductance mH
Milliampere mA
Millisecond ms
Minute min
Motion Control Tool MCT
Nanofarad nF
Newton Meters Nm
Nominal motor current I
M,N
Nominal motor frequency f
M,N
Nominal motor power P
M,N
Nominal motor voltage U
M,N
Parameter par.
Protective Extra Low Voltage PELV
Printed Circuit Board PCB
Rated Inverter Output Current I
INV
Revolutions Per Minute RPM
Regenerative terminals Regen
Second s
Synchronous Motor Speed n
s
Torque limit T
LIM
Volts V
The maximum output current I
VLT,MAX
The rated output current supplied by the
adjustable frequency drive
I
VLT,N
Introduction FC 300 Programming Guide
MG.33.MA.22 - VLT
®
is a registered Danfoss trademark 1-1
1 1

Danfoss FC 300 Series Specifications

General

Brand	Danfoss
Model	FC 300 Series
Category	DC Drives
Language	English