Danfoss VLT 5000 Series Manual

131
MG.10.J4.02 – VLT is a registered Danfoss trade mark
VLT
®
5000 SyncPos option
1 VELMAX
VELMAX defines the rated speed of the drive. This
value is listed in Rpm and is needed for the calcu-
lation of ramps and actual velocities.
NB!
The nominal speed refers to the speed of
the encoder.
Content
Rated speed of the drive
Parameter Group
AXV
Unit
Rpm
Value range
1 … 65535 ★ 3000
■■
■■
■ All SyncPos Parameters in Detail
The sequence of parameters is determined by the
internal parameter number. We recommend using
the overview as a guide; then you will be able to
find detailed information very quickly using the in-
ternal parameter number.
General Information on the Parameter Values
Some limiting values are listed at 1 billion to make
them more easily readable. However, the exact
value is 1,073,741,824.
NB!
The unit defined by the parameter
UserUser
UserUser
User
factorfactor
factorfactor
factor POSFACT_Z (23) and POSFACT_N
(26) is not used for all path and position parame-
ters. For various parameters (for example a soft-
ware limit switch like I_POSLIMITSW (46) and the
parameter
TT
TT
T
olerated position error olerated position error
olerated position error olerated position error
olerated position error POSERR(15)
the quad-count unit (qc) is valid.
4 quad-counts correspond to one sensor unit.
Abbreviation
For a description which is not dependent on the
version or the hardware, variables were used in the
following section for some limit values: thus the
value of
MLONG = 1.073.741.824
Factory settings
Each factory setting is marked with ★.
Input range
Whether the input range listed is exceeded is not
checked by the program, since due to the large
domain there is no suitable test possibilities.
NB!
Even within the areas indicated illogical
inputs can result from the large differences
in performance of the motors and the wide variety
of possible applications. Therefore, it is the
responsibility of the programmer and the user to
observe the performance ranges of the drive and
of the system.
Parameter Reference

Danfoss VLT 5000 Series Specifications

General

Brand	Danfoss
Model	VLT 5000 Series
Category	DC Drives
Language	English