Contents
1 How to Read these Operating Instructions
4
2 Safety
6
2.1 Safety Note
6
2.1.1 General Warning 6
2.1.2 Before Commencing Repair Work 7
2.1.3 Special Conditions 7
2.1.4 Avoid Unintended Start 7
2.1.5 Safe Torque Off (STO) 7
2.1.6 IT Mains 8
3 How to Install
9
3.1 How to Get Started
9
3.2 Pre-installation
9
3.2.1 Planning the Installation Site 9
3.2.2 Receiving the Frequency Converter 10
3.2.3 Transportation and Unpacking 10
3.2.4 Lifting 10
3.2.5 Mechanical Dimensions 12
3.2.6 Rated Power 18
3.3 Mechanical Installation
20
3.3.1 Tools Needed 20
3.3.2 General Considerations 20
3.3.3 Terminal Locations - Enclosure Type D 21
3.3.4 Terminal Locations - E Enclosures 24
3.3.5 Terminal Locations - Enclosure type F 29
3.3.6 Cooling and Airflow 33
3.3.7 Installation on the Wall - IP21 (NEMA 1) and IP54 (NEMA 12) Units 35
3.3.8 Gland/Conduit Entry - IP21 (NEMA 1) and IP54 (NEMA12) 35
3.3.9 IP21 Drip Shield Installation (Enclosure Types D1 and D2) 37
3.4 Field Installation of Options
37
3.4.1 Installation of Duct Cooling Kit in Rittal Enclosures 37
3.4.2 Outside Installation/NEMA 3R Kit for Rittal Enclosures 38
3.4.3 Installation on Pedestal 39
3.4.4 Installation of Input Plate Options 40
3.4.5 Installation of Mains Shield for Frequency Converters 41
3.5 Enclsoure Type F Panel Options
41
3.5.1 Enclsoure Type F Options 41
3.6 Electrical Installation
42
3.6.1 Power Connections 42
Contents VLT AQUA Drive FC 202 Operation Instructions
MG20P402 - Rev. 2013-12-16 1
To Next Page
Loading...
Need help?
General