1 How to Read these Operating Instructions
VLT AQUA Drive
FC 200 Series
Software version: 2.1x
This guide can be used with all FC
202 frequency converters with
software
version 2.1x or later.
The actual software version
number can be read from
15-43 Software Version.
This publication contains information proprietary to
Danfoss. By accepting and using this manual the user
agrees that the information contained herein is used solely
for operating equipment from Danfoss or equipment from
other vendors if such equipment is intended for communi-
cation with Danfoss equipment over a serial
communication link. This publication is protected under
the Copyright laws of Denmark and most other countries.
Danfoss does not warrant that a software program
produced according to the guidelines provided in this
manual functions properly in every physical, hardware or
software environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance,
or fitness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect,
special, incidental, or consequential damages arising out of
the use, or the inability to use information contained in
this manual, even if advised of the possibility of such
damages. In particular, Danfoss is not responsible for any
costs, including but not limited to those incurred as a
result of lost profits or revenue, loss or damage of
equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
Danfoss reserves the right to revise this publication at any
time and to make changes to its contents without prior
notice or any obligation to notify former or present users
of such revisions or changes.
1.1.1 Available Literature
•
VLT
®
AQUA Drive FC 202 Operating Instructions
provide the neccessary information for getting
the frequency converter up and running.
•
VLT
®
AQUA Drive FC 202, 110-1400 kW Operating
Instructions provide the neccessary information
for getting the high power frequency converter
up and running.
•
VLT
®
AQUA Drive FC 202 Design Guide entails all
technical information about the frequency
converter and customer design and applications.
•
VLT
®
AQUA Drive FC 202 Programming Guide
provides information on how to programme and
includes complete parameter descriptions.
•
VLT
®
AQUA Drive FC 202 Profibus
•
VLT
®
AQUA Drive FC 202 DeviceNet
•
Output Filters Design Guide
•
VLT
®
AQUA Drive FC 202 Cascade Controller
•
Application Note MN20A: Submersible Pump
Application
•
Application Note MN20: Master/Follower Operation
Application
•
Application Note MN20F: Drive Closed Loop and
Sleep Mode
•
Installation Instruction for Mounting Brackets
Enclosure type A5, B1, B2, C1 and C2 IP21, IP55 or
IP66
•
Instruction for Analog I/O Option MCB109
•
Instruction for Panel through mount kit
•
VLT
®
Active Filter Operating Instruction
Danfoss technical literature is also available online at
www.danfoss.com/BusinessAreas/DrivesSolutions/
Documentations/Technical+Documentation.htm.
How to Read these Operating... VLT AQUA Drive FC 202 Operation Instructions
4 MG20P402 - Rev. 2013-12-16
1
1
To Next Page
Loading...
Need help?
General