Danfoss VLT AutomationDrive FC 360 Programming Guide

Programming Guide | VLT® AutomationDrive FC 360
Show the temperature measured at input X48/4.
18-38 Temp. Input X48/7
Default value: 0 Parameter type: Range (-500–500)
Setup: All setups Conversion index: 0
Data type: Int16 Change during operation: True
Show the temperature measured at input X48/7.
18-39 Temp. Input X48/10
Default value: 0 Parameter type: Range (-500–500)
Setup: All setups Conversion index: 0
Data type: Int16 Change during operation: True
Show the temperature measured at input X48/10.
4.17.2 18-5* Active Alarm/Warning Number
18-55 Active Alarm Number
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
This parameter contains a highest priority alarm number that is active. The value 0 means no alarm.
18-56 Active Warning Number
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
This parameter contains a highest priority warning number that is active. The value 0 means no warning.
4.17.3 18-6* Motor Status 2
18-66 Switching Frequency
Default value: 0 kHz Parameter type: Range (0–32 kHz)
Setup: 1 setup Conversion index: 0
Data type: Int8 Change during operation: True
Show the actual switching frequency. The actual switching frequency could not be same with the set value in parameter14-01 Switching
Frequency due to internal derating.
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 271

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English