Enter/Exit Programming Mode 2D Global Features
190
PowerScan™ PD953X/PBT950X/PM950X
PDF417 Set Length 1
Specifies one of the bar code lengths for PDF417 Length Control. Length 1 is
the minimum label length if in Va
riable Length Mode, or the first fixed
length if in Fixed Length Mode. Length includes the bar code’s data charac-
ters only. Characters can be set from 00
01 to 2,710 characters (pad with
zeroes) in increments of 01. Any value greater than 2,710 will be considered
to be 2,710.
See page 281 for detailed instructions on setting this feature.
Select PDF417 Length 1 Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning
the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
