Enter/Exit Programming Mode
Product Reference Guide
75
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
Aiming Pointer = Disable
Aiming Pointer = Enable
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a
label, when in trigger single mode.The range for this setting is from 1 to
255 seconds in 1-second increments. See page 296 in “References” for a
description of this feature.
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
representing your
desired character(s). End by
scanning the ENTER/
EXIT bar code.
Make a mistake? Scan the CANCEL bar code t
o abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
To Next Page
Loading...
Need help?
General
