Enter/Exit Programming Mode
56
PowerScan™ PD953X/PBT950X/PM950X
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To
set, first define whether you want it as a prefix or suffix by scanning a label
below. Then turn to Label ID Symbology Selection − 1D
Symbologies, starting on page 57 to select the symbology you want to set,
followed by up to 3 characters from the ASCII Chart at the back of this man-
ual. See "Label ID: S
et Individually Per Symbology" on page 289 for detailed
instructions on setting this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or
suffix for a given symbology type.
Label ID Transmission = Disable
Label ID Transmission = Enable as Prefix
Label ID Transmission = Enable as Suffix
To Next Page
Loading...
Need help?
General
