Datalogic PowerScan PBT950X User Manual

Enter/Exit Programming Mode
246 PowerScan™ PD953X/PBT950X/PM950X
Display Off Timeout
Sets the timeout for display, backlight and keyboard.
Display Off Timeout = Disabled
$CDIOT
Set Display Off Timeout
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the ENTER/EXIT ba
r code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
08 = 8 second delay
Backlight Enable
Enables/Disables the display backlight.
DEFAULT
$CDIBL00\r
Backlight Disabled
$CDIBL01\r
Backlight Enabled

Datalogic PowerScan PBT950X Specifications

General

Brand	Datalogic
Model	PowerScan PBT950X
Category	Barcode Reader
Language	English