Customizing Configuration Settings
Product Reference Guide
21
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface bar code from the previous table, your installation requires you to
select options to further customize your reader, turn to the appropriate section for your inter-
face type in "Configuration Parameters" starting on page 23.
• "RS-232 Interface" on
page 27
• "RS-232/USB-Com Interfaces" on pa
ge 32
• "Keyboard Settings" on pa
ge 39
Global Interface Features
See "Global Interface Features" on page 25 for settings configurable by all interface types.
Configuring Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
Data Format
:
Data Format offers options to control the messages sent to the Host system.
Reading Parameters
:
Reading Parameters include programming for scanning, beeper and LED
indicators and other universal settings.
Symbology-Specific Parameters
1D Symbologies
:
Includes options concerning the bar code label types (symbologies). These
settings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
2D Symbologies
:
Includes options concerning the bar code label types (symbologies). These
settings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by scanning the following label.
Transmit Software Version
RevA
To Next Page
Loading...
Need help?
General
