156 Running the System Diagnostics
•
Test Iterations
— Selects the number of times the test is run.
•
Log output file pathname
— When checked, enables you to specify the
diskette drive or USB memory key where the test log file is saved. You
cannot save the file to a hard drive.
Viewing Information and Results
The tabs in the Customize window provide information about the test and
the test results. The following tabs are available:
•
Results
— Displays the test that ran and the result.
•
Errors
— Displays any errors that occurred during the test.
•
Help
— Displays information about the currently selected device,
component, or test.
•
Configuration
— Displays basic configuration information about the
currently selected device.
•
Parameters
— If applicable, displays parameters that you can set for the
test.
book.book Page 156 Sunday, June 21, 2009 5:16 PM
To Next Page
Loading...
Need help?
General