Dell PowerEdge R300 User Manual

About Your System 35
Table 1-7. System Messages
Message Causes Corrective Actions
Alert! DIMM1_A and
DIMM1_B must be
populated with a
matched set of
DIMMs if more than
one DIMM is
present. The
following memory
DIMMs have been
disabled:
If more than one DIMM
is present, DIMMs must
be installed in matching
pairs.
Check other system
messages for additional
information for possible
causes. For memory
configuration information,
see "Memory Module
Installation Guidelines" on
page 103. If the problem
persists, see
"Troubleshooting System
Memory" on page 137.
Alert! Unsupported
memory, incomplete
sets, or unmatched
sets. The following
memory is disabled:
Unsupported DIMMs,
mismatched DIMMs, or
unmatched DIMMs have
been detected. If more
than one DIMM is
present, DIMMs must be
installed in matching
pairs.
For memory configuration
information, see "Memory
Module Installation
Guidelines" on page 103. If
the problem persists, see
"Troubleshooting System
Memory" on page 137.
Attempting to
update Remote
Configuration.
Please wait...
Remote Configuration
request has been detected
and is being processed.
Wait until the process is
complete.
BIOS Update Attempt
Failed!
Remote BIOS update
attempt failed.
Retry the BIOS update. If
problem persists, see
"Getting Help" on page 167.
Caution! NVRAM_CLR
jumper is installed
on system board.
NVRAM_CLR jumper is
installed. CMOS has been
cleared.
Remove NVRAM_CLR
jumper. See Figure 6-1 for
jumper location.
Decreasing
available memory
Faulty or improperly
installed memory
modules.
See "Troubleshooting System
Memory" on page 137.
book.book Page 35 Sunday, June 21, 2009 5:16 PM

Dell PowerEdge R300 Specifications

General

Brand	Dell
Model	PowerEdge R300
Category	Server
Language	English