Delta AH Series Hardware Manual

AH Motion Controller – Hardware Manual
5-4
_5
5.3 Periodic Maintenance
Under the condition that the daily inspection is undertaken, users are suggested that they should carry out the periodic
maintenance according to the actual operating environment. After making sure that the ambient environment and the AH
Motion system conform to the cautions listed in section 5.1, users then can undertake the periodic inspection described
below. If any abnormal situation occurs, please follow the suggested actions and carry out the maintenance.
5.3.1 Tools Required for Inspection
 A screwdriver
 Industrial alcohol
 A clean cotton cloth
 A multimeter
 A thermometer
 A hygrometer
5.3.2 Periodic Inspection
No. Item Inspection Criterion Action
1
Ambient environment
Ambient
temperature/hu
midity
The ambient temperature and
the ambient humidity are
measured by a thermometer
and a hygrometer.
The ambient temperature and the
ambient humidity must conform
to the specifications for the
modules or the backplane. If the
specifications are different, the
strictest specifications have high
priority.
To ensure that the
system operates in a
stable environment,
check the reason why
the environment
varies, and correct it.
Atmosphere Measure corrosive gas.
Corrosive gas must not be
present.
2 Supply voltage
Measure the AC power
supply.
The power supply should meet
the specifications for the power
supply module.
Check the power
supply.
3
Installation
Looseness
Check whether the module is
loose.
The module must be installed
firmly.
Please refer to
chapter 4 for more
information about
installing the module.
Adhesion of dirt Check the appearance. Dirt must not be present. Remove the dirt.
4
Connection
Looseness of
terminal screws
Tighten the screws with a
screwdriver.
The screws must not be loose.
Further tighten the
screws.
Looseness of
connectors
Pull the connectors.
The connectors must not be
loose.
Further tighten the
screws on the
connectors.
5 PLC system diagnosis Check the error logs. No new error occurs.
Please refer to AH
Motion Controller –
Operation Manual
for more information
regarding
troubleshooting and
error logs.

Delta AH Series Specifications

General

Brand	Delta
Model	AH Series
Category	Controller
Language	English