Chapter 12 Descriptions of Parameter SettingsMS300
441
13 Industry Application Parameters
You can set this parameter during operation.
Industry-Specific Parameter Application
00: Disabled
01: User-defined parameter
02: Compressor
03: Fan
04: Pump
05: Conveyor
06: Machine tool
07: Packing
08: Textiles
10: Logistics
11: Tension PID
12: Tension PID + master / auxiliary frequency
NOTE: after you select the macro, some of the default values adjust automatically according to
the application selection.
Setting 02: Compressor
The following table lists the relevant compressor setting application parameters.
Master frequency command source
(AUTO, REMOTE)
2 (External analog input)
Operation command source
(AUTO, REMOTE)
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point frequency 1 of motor 1
Mid-point voltage 1 of motor 1
Mid-point frequency 2 of motor 1
Mid-point voltage 2 of motor 1
Minimum output frequency of motor 1
Minimum output voltage of motor 1
Output frequency lower limit
To Next Page
Loading...
Need help?
General