Denon AVR-390 User Manual


Getting Started Playback Information Troubleshooting
ENGLISH
Specications
q After performing the steps 1 ~ 3 in “Adjusting the Current Channel
Level” procedure on page 18, press MEMORY/ENTER.
The “1” of “REFERENCE 1” indication flashes.
w Press o p to select the desired preset memory, then press
MEMORY/ENTER.
b Each time o p is pressed, “REFERENCE 1” or “REFERENCE 2”
is selected.
b The adjusted channel levels have now been memorized into the
selected memory.
Channel Level Setup
NOTE
Speakerset to “N”inthe “Speaker Conguration”settingsare not
displayed.
Adjust channel levels to obtain equal volume from all speakers.
[Display]
d
f
MEMORY/ENTER
[CH SELECT]
uiop
MEMORY/ENTER
op ui
Button located on both the main unit and the remote
control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
Adjusting the Current Channel
Level
You can adjust the current channel levels as desired. These
adjusted levels are just memorized into user’s memory
(“REFERENCE 1”).
After adjusting each channel level with test tone, adjust the
channel levels either according to the program sources or to suit
your tastes. (For details, refer to “Adjusting Each Channel Level
with Test Tone” on page 28.)
Memorizing the Adjusted Channel
Levels
Youcanmemorizetheadjustedchannellevelsintopresetmemory
(“REFERENCE 1”, “REFERENCE 2”) and recall the memorized
whenever you want.
Select the Channel Level
This selects the memorized channel level.
q Press [CH SELECT].
w Press o p to select the mode (“REFERENCE 1” or “REFERENCE
2”).
e After selecting the mode, press [CH SELECT] once again.
The display returns to normal.
w
Press o p to adjust the level of the selected channel or program
source’s LFE as desired.
[Variable range]
Other level :
–15dB
~
0dB
~
+15dB
LFE level :
–10dB
~
0dB
b In general, we recommend the LFE level to be adjusted to 0
dB. (However, the recommended LFE level for some early DTS
softwareis−10dB.)Iftherecommendedlevelsseemtoohigh,
lower setting as necessary.
e Repeat the above steps 1 and 2 to adjust each channel level.
q Press ui to select the desired channel.
The speaker that can be set switches each time one of the
buttons is pressed.
FL C FR
SR
MODE:REF1
SL SW DD DTS
Connections Setup
For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 15).

Denon AVR-390 Specifications

General

Brand	Denon
Model	AVR-390
Category	Receiver
Language	English