Denon AVR-390 User Manual


Getting Started Connections Setup Information Troubleshooting
ENGLISH
Specications
Press STATUS.
The current program source and various settings are indicated on
the display.
For details, refer to “Information” (vpage 21).
Checking the currently playing program source, etc.
Switching the brightness of the display
Press [DIMMER].
Bright Dim
OFF
Playing Video and Audio
Equipment
1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor’s operating instructions.)
2
Use INPUT SELECT to select the input source.
3
Start playback.
(vSee the operating instructions of the respective devices.)
Basic Operation
Either turn <MASTER VOLUME> or press [MASTER
VOLUME].
[Variable range]
0 dB ~ 80 dB
Operations During Playback
Adjusting the Master Volume
Plug the headphones into the PHONES jack on the main
unit.
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
Be careful not to set the volume too high when using headphones.
Listening with Headphones
Press [MUTE].
The display shows “MUTE”.
To cancel, press [MUTE] again. Muting can also be canceled by
adjusting the master volume.
Turning Off the Sound Temporarily (Muting)
NOTE
The adjustable range will differ depending upon factors such as the
type of input signal and the channel level setting.
The display shows “MIN” when you select “0 dB”.
The display shows “MAX” when you select “80 dB”.
Automatically Presetting FM Stations
(Auto Preset)
Up to 30 stations can be preset.
Auto preset is not possible with AM broadcast stations.
1
Press <TUNER> or [BAND] to select “FM”.
2
Press and hold in MEMORY/ENTER.
“AUTOMEM”ashes.
1
Press TUNER to select “TUNER”.
2
Press <TUNER> or [BAND] to select “FM” or “AM”.
3
Tune in the desired broadcast station.
q To tune in automatically (Auto Tuning)
Press and hold in <TUNING d f> to automatically search and
tune in broadcast stations.
b Stations whose signal is weak cannot be turned in.
b When auto tuning stops, press <TUNING df>.
w To tune in manually (Manual Tuning)
The reception frequency switches each time <TUNING df> is
pressed.
Listening to FM/AM Broadcasts
If the desired station cannot be tuned in with auto tuning, tune it in
manually.
Basic Operation
See page 29 for tuning interval change mode.
Playback
• Broadcast stations whose antenna signal are weak cannot be
preset automatically. If you wish to preset such stations, tune them
in manually.
• Once auto presetting starts, it cannot be stopped before it is
completed. (It takes about 60 seconds for auto presetting to be
completed.)

Denon AVR-390 Specifications

General

Brand	Denon
Model	AVR-390
Category	Receiver
Language	English