0
Getting Started Connections Playback Information Troubleshooting
ENGLISH
Specications
Parameter
d
f
[TONE]
NIGHT
ENTER
uiop
[SURROUND
PARAMETER]
Adjust surround sound parameters.
The parameters (items) which can be adjusted differ depending upon the following conditions.
• Whether an input signal is present (when playing) or not (when stopped, etc.).
• The type of input signal
• The type of surround mode
For details of which parameters can be adjusted in each surround mode, see “Surround Modes and Parameters” (vpage 31).
Tone Control
Turn tone adjustments on and off.
In general, we recommend the bass and treble to be adjusted to 0
dB(atlevel).
NOTE
• When the EXT. IN is selected as an input source, you can neither
select the tone mode nor adjust the tone.
• Extreme settings at high volume may damage your speakers.
Operating from the remote control unit
q Press [TONE].
The display shows the currently set tone mode.
w Press o p to select the desired tone mode.
e Press ui to select the desired tone.
r Press o p to adjust the selected tone as desired.
b To complete tone adjustment, repeat the above steps 3 and 4.
b If the tone display disappears, start from the step 1 again.
[Variable range]
–10dB
~
0dB
~
+10dB
[Variable range]
–10dB
~
0dB
~
+10dB
“Bass” and “Treble” can be set when “Tone Control” is set to “ON”.
Bass
Adjust low frequency range (bass).
Treble
Adjust high frequency range (treble).
[Selectable items]
ON
: Allow tone adjustment (treble, bass).
OFF
: Playback without tone adjustment.
[Display]
Button located on both the main unit and the remote
control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Youcanchangethe“Bass”and“Treble”settingswhenyouset“Tone
Control” to “ON” and press ENTER.
“TRBL” is displayed.
Setup
For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 15).
To Next Page
Loading...
Need help?
General
