Connections Setup Playback Information Troubleshooting
ENGLISH
Specications
Inserting the Batteries
NOTE
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
• The supplied batteries are only for verifying operation.
• When inserting the batteries, be sure to do so in the proper direction,
following the “q” and “w” marks in the battery compartment.
•Topreventdamageorleakageofbatteryuid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
ames.
•Ifthebatteryuidshouldleak,carefullywipetheuidofftheinside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be in
use for long periods.
• When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
30°
30°
Approx. 7 m
Operating Range of the Remote Control
Unit
Point the remote control unit at the remote sensor when operating
it.
NOTE
The set may function improperly or the remote control unit may not
operate if the remote control sensor is exposed to direct sunlight,
strongarticiallightfromaninvertertypeuorescentlamporinfrared
light.
About the Remote Control Unit
q Lift the clasp and remove the rear cover.
e Put the rear cover back on.
R03/AAA
w Load the two batteries properly as indicated
by the marks in the battery compartment.
Getting Started
To Next Page
Loading...
Need help?
General
