Denon AVR-X7200W User Manual

o
Desired sound does not come out
Symptom Cause / Solution Page
The volume does not
increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu. 198
0
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
－
No sound comes out with
the HDMI connection.
0
Check the connection of the HDMI connectors. 66
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output
from the TV, set “TV”.
208
0
When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV. 168
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected. 43
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu. 259
0
Check the “Assign Mode” setting in the menu. 235
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and subwoofer. －
No sound is produced from
subwoofer.
0
Check the subwoofer connections. 44
0
Turn on the subwoofer’s power. －
0
Set “Speaker Config.” - “Subwoofer” in the menu to “1 spkr” or “2 spkrs”. 260
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
259
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
267
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. 267
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”. －
0
Set “Decode Mode” on the menu to “Auto” or “DTS”. 223
Dolby Atmos, Dolby
TrueHD, DTS-HD, Dolby
Digital Plus audio is not
output.
0
Make HDMI connections. 70
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by
default.
－
Contents Connections Playback Settings Tips Appendix
314
Front panel Display Rear panel Remote Index

Denon AVR-X7200W Specifications

General

Receiver type	Surround
Input sensitivity	200 mV
Audio output channels	11.2 channels
Signal-to-Noise Ratio (SNR)	102 dB
Power output per channel (1KHz@6 Ohm)	190 W
Power output per channel (20-20KHz@8 Ohm)	210 W
HDMI in	8
Audio (L/R) in	7
Composite video in	5
Digital audio optical in	2
Ethernet LAN (RJ-45) ports	1
Component video (YPbPr/YCbCr) in	3
12V trigger	Yes
Speakers connectivity type	-
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Optical drive included	No
Display	LCD
Product color	Black
Audio decoders	Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	780 W

Weight and Dimensions

Depth	427 mm
Width	434 mm
Height	196 mm
Weight	17800 g