Digi Connect SP User Manual

Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
93
1. Configure the wireless card to operate in Ad-Hoc mode with the SSID - Connect.
2. Power up the device.
3. Launch the Discovery application on you computer and proceed with the configuration.
Set DIP switches on Digi Connect Wi-SP (or SP)
To set the DIP switches on Digi Connect Wi-SP (or SP):
1. Disconnect the power supply.
Note ALWAYS disconnect the power supply before resetting the DIPswitches.
2. Set the Digi Connect Wi-SP DIP switches in the On or up position. The following image shows
the DIP Switch settings required for command-line access for both the Digi Connect Wi-SP and
the Digi Connect SP.
3. Connect the Digi Connect Wi-SP to a computer with a serial cable.
4. Access a terminal emulation program such as HyperTerm. For example, select Start >
Accessories > Communication > Hyperterm and type a name for the connection.
5. Select COM1 and click OK.

Digi Connect SP Specifications

General

Brand	Digi
Model	Connect SP
Category	Server
Language	English