Domino F Series User Guide

30
Switching On and Off
WARNINGS: (1) The laser marking system must only be used
for its intended purpose.
(2) The laser marking system may only be
operated by trained personnel.
(3) Operation is only allowed with all required
cables connected and all parts mounted. Do
not disconnect any cables during operation.
CAUTION: The lens cap must be removed before operation.
Switching On the Control Unit
Turn on the laser unit F220i first by switching the switch from position
“0” to “1”. At the control panel, release the On/Off button by turning it
clockwise. Wait until the SERVER RUNNING indicator has
illuminated.
Switching On the Laser Head
Turn the key switch from position “0” to position “1”. To start the laser
turn the key clockwise to the laser symbol and hold it for at least 1
second. The key automatically turns back to position “1”.
• The laser needs a warm-up phase of 3 seconds.
The PRINTER BUSY indicator will illuminate when the laser
hardware is switched on.
The PRINTER READY indicator illuminates. After initialising the
Dynamark 3 software and starting the lasers, the marking system is
ready.
Laser emission is also displayed by a red LED on the rear of the laser
unit.

Domino F Series Specifications

General

Brand	Domino
Model	F Series
Category	Measuring Instruments
Language	English