DSC PowerSeries Neo HS2016-4 User Manual

Chapter 4
4.0 Securing the Premises
The PowerSeries Neo provides multiple arming modes as described below:
Away mode
Use when no one in your household will be home. Away mode activates all peri-
meter and interior sensors in the alarm system.
Stay mode
Use this mode when you are staying home, but expect someone to use the entrance
door later. Stay mode partially activates your alarm system by arming all perimeter
sensors and bypassing all interior sensors.
Night mode
Use when you want the perimeter and interior armed but would like to allow limited
movement in your house without activating the alarm. (e.g., disable motion sensors
in an area containing bedrooms and a washroom). Night mode is similar to Stay
mode but only bypasses internal sensors configured as Night Zones.
NOTE: Verify with your alarm company which modes are available on your system. For SIA FAR listed
panels, the Stay Arming Exit Delay will be twice as long as the Away Arming Exit Delay.
Depending on your system configuration, there are multiple methods you can use to arm your system.
You can arm the system using a:
l Keypad
l 2-way wireless key
See also:
l Silent Exit Delay
4.1 Arming the System
The PowerSeries Neo system can be set/armed using a keypad, a 2-way wireless key or a proximity tag.
4.1.1 Arming the System (Infinite Exit Delay)
In an attempt to reduce false alarms, your system is designed to notify you of an improper exit when arm-
ing the system. When using the Push to Set, or Final Door Set feature, attempting to arm your system will
start an infinite exit delay. The keypad will sound a beep once per second. When you have opened and
closed the final exit door, or after pressing the Push to Set button, the exit delay will be reduced to a pro-
grammable value, which is typically 10 seconds, after which the alarm will complete the setting. The
panel used this time period to allow time for the detectors on the system to return to their normal state.
When this time expires, the system checks for detectors/windows/doors that may be open. If any of these
are open, the panel will cancel the arming. If this occurs, you must re-enter the premises, check the sys-
tem, close any open zones, and then attempt to arm again.
4.1.2 Away Arming the System with the Keypad
Away mode activates the complete alarm system by:
l Arming all perimeter sensors.
l Arming all interior sensors.
To Arm the System in Away Mode:
LCD Display
1. Ensure all windows and doors are closed and that the Ready indic-
ator is on.
Date Time
JAN 02/18 2:06a
2. To arm using the Away key , press and hold the Away key for 2
seconds and, if required, enter your [access code] or present your
proximity tag.
OR
To Quick Arm the system press [*][0].
System is
Ready to Arm
then
Present Tag or
Enter Code
3. If zones have been bypassed, ICN or LED keypads bypass LED
will light and the bypassed zones #s will be shown. On an LCD
keypad a warning appears.
* Warning *
Bypass Active
- 10 -

DSC PowerSeries Neo HS2016-4 Specifications

General

Brand	DSC
Model	PowerSeries Neo HS2016-4
Category	Security System
Language	English