Chapter 8
8.0 User Functions
The PowerSeries Neo allows for a variety of user configurable functions as listed below:
Event Buffer Auto Arm Time Late To Open Contrast Control Voice Chime
Time and Date System Service/DLS Late To Open Time Buzzer Control User's Walk Test
Auto Arm/Disarm User Call-Up Brightness Control Voice Prompt
NOTE: User Functions can only be modified when the system is disarmed.
To access the User Function menu LCD Display
1. Press [*][6]
OR
press [*] and use the scroll keys to navigate to User Functions and
press [*].
Press (*) for <>
User Functions
2. Enter Master code and scroll through the options listed above.
Present Tag or
Enter Code
then
Select Option <>
Event Buffers
3. To go back to the Ready state press [*].
8.1 Event Buffer
The Event Buffer displays a list of the last 1000 events on your system. You may only view the event buf-
fer using an LCD keypad.
To view the Event Buffer LCD Display
1. From the User Function menu scroll to Event Buffer and
press [*].
Select Option <>
Event Buffer
2. Press to scroll through the Event Buffer. When finished press
[*] to return to the Ready state.
000X-Message
Time/Date
8.2 Setting the Time and Date
To set the time and date:
LCD Display
1. From the User Function menu use the shortcut key [0][1] or press the
scroll keys to Time and Date and press [*].
Select Option <>
Time and Date
2. Use the number keys to set the time and date. When finished press
[*] to return to the Ready state.
HH:MM MM/DD/YY
11:12 01/14/19
8.3 Enabling/Disabling the Auto Arm/Disarm Feature
NOTE: Access to this feature must be configured by installer.
To enable/disable Auto Arm/Disarm
LCD Display
1. From the User Function menu use the shortcut key [0][2] or press the
scroll keys to Auto Arm/Disarm.
Press (*) for <>
Auto Arm/Disarm
2. Press [*] to enable/disable the Auto Arm/Disarm feature.
Auto Arm/Disarm
is Enabled
or
Auto Arm/Disarm
is Disabled
3. When finished press [*] to return to the Ready state.
- 28 -
To Next Page
Loading...
Need help?
General
