*
4. Press the SET key to fix ‘Manual mode’.
5. ‘Manual mode switching screen’ appears on the
LCD panel. Select ‘ON’ using the CURSOR keys
(Right/Left) and press the SET key.
6. ‘Entering setting’ is displayed on the LCD panel
and stand-by screen appears.
In manual mode, icon ’ * ’ appears on the LCD
panel.
This section describes the procedures to create a JOB and to set fold type using A3 paper
(420mm×297mm). You can register up to 80 JOBs from JOB No. 01 to 80.
1. Confirm that the LCD panel displays stand-by
screen.
Right illustration: JOB No. which JOB is not
registered is displayed as
‘No Data’.
2-2. Entering JOB on the control panel (only in manual mode)
To Next Page
Loading...
Need help?
General
