18 Washing - ENGLISH
Start washing
NOTE!
To save energy, in standby mode, the dishwasher will automatically turn off if it has not been used for 15
minutes.
1. Turn on the water supply.
2. Slide out the lower and upper baskets.
3. Load the dishes.
WARNING! Knives and other utensils with sharp points must be loaded in the basket with their points facing
down or placed in a horizontal position.
4. Push the lower and upper baskets back.
5. Add detergent in the detergent dispenser. See section "Fill the detergent dispenser", page 19.
NOTE! Only use detergents recommended for use in dishwasher. Never use soap, laundry detergent or hand
washing detergent in the dishwasher.
6. Close the door.
7.
Press to turn on the power.
8.
Press to select a programme.
The selected programme's indicator light is lit.
9. Select settings and options if needed.
10.
Press to start the wash cycle.
When the washing is completed an acoustic signal sounds and the dishwasher door opens.
WARNING!
Do not empty your dishwasher immediately after washing, items will be hot. Wait for 15 minutes before
emptying the dishwasher.
Add dishes during a wash
You can add more dishes to a wash any time before the detergent dispenser opens.
WARNING!
It is dangerous to open the door mid-cycle, as hot steam may scald you.
1.
Press to pause the wash cycle.
2. Wait for 5 seconds and then open the door.
3. Add the dishes.
4. Close the door.
5.
Press to resume washing.
Change programme during a wash
You can change the programme any time by performing a reset.
1.
Press to pause the wash cycle.
2.
Press and hold for more than 3 seconds to cancel the programme.
3. Check if the detergent dispenser is open. If it is open, refill the detergent dispenser with detergent.
4.
Press to select a programme.
5.
Press to start the wash cycle.
After 10 seconds the dishwasher will start.
To Next Page
Loading...
Need help?
General
