50 Troubleshooting - ENGLISH
The programme was not powerful enough
Select a more vigorous programme.
Not enough detergent was dispensed
Use more detergent, or change your detergent.
Items are blocking the movement of the spray arms
Rearrange the items so that the spray can rotate freely.
The filter assembly is not clean or is not correctly fitted in the base of the dishwasher cabinet. This may lead to
blockage of the spray arm jets
• Clean and fit the filter correctly. See section "Remove and clean the filtering system", page 40.
• Clean the spray arm jets. See section "Clean the spray arms", page 38.
Cloudiness on glassware
Combination of soft water and too much detergent
Use less detergent if you have soft water and select a shorter cycle to wash the glassware and to get it clean.
There are rust stains on the cutlery
The problem can have different causes. Follow the instructions for the suggested causes to solve the problem.
The affected items are not corrosion resistant
Avoid washing items that are not corrosion resistant in the dishwasher.
A programme was not run after dishwasher salt was added. Traces of salt have gotten into the wash cycle
Always run a wash programme without any crockery after adding salt.
The lid of the water softener is loose
Check that the lid is secure.
White spots appear on dishes and glasses
Hard water can cause limescale deposits
• Adjust the water softener level. See section "Adjust the water softener level", page 15.
• Add salt to the water softener. See section "Add salt to the water softener", page 22.
Black or grey marks on dishes
Aluminium utensils have rubbed against dishes
Use a mild abrasive cleaner to eliminate the marks.
The dishes are not drying
The problem can have different causes. Follow the instructions for the suggested causes to solve the problem.
Improper loading
See section "Loading the dishwasher efficiently", page 0.
To Next Page
Loading...
Need help?
General
