EMS FirePoint 5000 User Manual

EMS 5000 FIREPOINT
ENGINEERS OPERATING GUIDE, ISSUE 3.0 – 16/08/10
13
11 Press the “0” key and the screen will
now display:
12 Enter the device number that you want to
Disable (e.g. 125) then press the “YES” key and
screen will now display:
13 Press the “∇” key once and the screen will
display:
14 Press the “YES” key once the screen will now
display:
15 Press the “∇” key once and the screen will
display:
16 Press the “YES” key once the Screen will now
display:
17 Press the “NO” key three times and the screen
will display:
18 Turn the Control key to the “OFF”
Position. The screen will now display:
Note: The “DETECTOR/ZONE DISABLED” LED on the 5000 FirePoint
Master Panel and the 5000 FirePoint Slave Panel 04 will illuminate with
intermittent beep to show there’s a disablement on the system.
Enter Device
(Number 1-256)
Number > _
Yes = Finish Time
| Panel : 04 |
>Device : 125 <
| Status : Active |
Yes= Select Time
| Device : 125 |
> Status : Active <
| Transmit Event |
Yes= Select Time
| Device : 125 |
>Status : Disable<
| Transmit Event |
Yes= Select Time
|Status : Disable |
>Transmit Event <
|^^^^^^^^^^^^^^ |
Yes= Select Time
Device 125 on NET 04
Set to DISABLED
Push Any Key Time
Panel in Access
Date Time
Status Normal
Date
Time

EMS FirePoint 5000 Specifications

General

Brand	EMS
Model	FirePoint 5000
Category	Control Panel
Language	English