EMS 5000 FIREPOINT
ENGINEERS OPERATING GUIDE, ISSUE 3.0 – 16/08/10
27
7 Press Number 8 on the keypad and the screen
will now display: (number is a quick move key
that take you to the bottom of the menu)
8
Press the “∆” key once and the screen will now
display:
9
Press the “YES” key followed “0” key
on the Keypad the screen will now
display:
10 Press Number 8 on the keypad and
the screen will now display: (number is a quick
move key that take you to the bottom of the
menu)
11
Press the “YES” key and the screen will now
display:
12
Press the “∇” key until the screen displays:
13
Press the “YES” key and the screen will now
display:
14
Press the “∇” key until the screen
displays:
15
Press the “YES” key and the screen will now
display:
16
Press the “∇” key and the screen will display:
17
Press the “YES” key, the screen will stay the
same but the test LED will start flashing to
show that all the zones are in test.
NOTE: Check the other panels to make sure the “TEST MODE” LED is
flashing to ensure no Sounders/Relays will activate.
| Reset System |
>Lan Options <
|^^^^^^^^^^^^^^ |
Yes= Select Time
| Reset Security |
> Reset System <
| Lan Options |
Yes= Select Time
|** Main Menu ** |
> Pins & Access <
| System Support |
Yes= Select Time
| Radio Lan |
> Fire DB <
| ^^^^^^^^^^^^^^ |
Yes= Select Time
|** Lan Fire DB ** |
> H/W Local Panels <
| Mimic |
Yes= Select Time
| Mimic |
>Advanced <
|^^^^^^^^^^^^^^ |
Yes= Select Time
|*** Advanced *** |
>Get Slave Bus Lsts<
|^^^^^^^^^^^^^^^ |
Yes= Select Time
| Local Mimic |
>Set Det.Zones <
| Announce All Clear|
Yes= Select Time
|* Set All Zones * |
> ACTIVE <
| TEST |
Yes= Select Time
| ACTIVE |
> TEST <
| DISABLED |
Yes= Select Time
| ACTIVE |
> TEST <
| DISABLED |
Yes= Select Time