Ephoca HPAC 2.0 User Manual

18
COOLING MODE
In this cooling mode, the HPAC 2.0 cools and dehumidifies the room. The fan will consistently
operate.
To activate cooling mode press the cooling button.
Use the up and down arrows to set the desired temperature between 61°F and
87°F.
ATTENTION
At startup, it can take up to three minutes for the HPAC 2.0 to
start supplying cool air.
TEMPERATURE SETPOINT DISPLAY
When the HPAC 2.0 is turned on, the three digits on the display will show the
desired temperature.
It is possible to set the desired temperature between 61°F and 87°F. The HPAC 2.0
will bring the room to the desired temperature.
NOTICE
If the temperature is set too low or too high, it can be unhealthy
and an unnecessary waste of energy.
The HPAC 2.0 will periodically defrost the evaporator coil, if necessary. During the defrosting
phase, the HPAC 2.0 does not supply warm air.
POWER ON/OFF
Power the HPAC 2.0 on or off (standby) by pressing the Power button. The control
system of the HPAC 2.0 is equipped with a memory, so settings will not be lost if
the HPAC 2.0 is turned off or there is a loss of power.
The Power button is used to activate or deactivate the HPAC 2.0 for short time
periods only. In the case of long periods of inactivity, the HPAC 2.0 must be
unplugged from the power grounded three-prong electrical power outlet.

Ephoca HPAC 2.0 Specifications

General

Brand	Ephoca
Model	HPAC 2.0
Category	Heat Pump
Language	English