Ephoca HPAC 2.0 User Manual

22
TIMER FUNCTIONS
The Timer enables the user to program when to turn the HPAC 2.0 on and off.
TO PROGRAM HPAC 2.0 TO TURN OFF
While the HPAC 2.0 is operating, press the Timer button, and then use the up and
down arrows to select in how many hours you want the HPAC 2.0 to turn off. After
selecting the number of hours, press the Timer button again.
TO PROGRAM HPAC 2.0 TO TURN ON
When the HPAC 2.0 is off, press the Timer button and then use the up and down
arrows to select in how many hours you want the HPAC 2.0 to turn on. After
selecting the number of hours, press the Timer button again.
Once confirmed the display will temporarily show the temperature, mode and fan speed that
will be working when the timer activates. The Timer button will remain lit.
DISPLAY BRIGHTNESS
The Display Brightness sensor is factory-set to automatically adjust to the light of the room.
When the room is dark the display automatically dims. This automatic brightness adjustment
can be disabled, if desired..
To disable, press and hold the Sleep button for 10 seconds. “Ds” (disabled) will appear
on the display.
To re-enable, press and hold the sleep button for 10 seconds. “En” (enabled) will
appear on the display.

Ephoca HPAC 2.0 Specifications

General

Brand	Ephoca
Model	HPAC 2.0
Category	Heat Pump
Language	English