Ephoca HPAC 2.0 User Manual

19
HEATING MODE
In heating mode, the HPAC 2.0 heats the room.
To activate heating mode, press the heating button
Use the up and down arrows to set the desired temperature between 61°F and
87°F.
ATTENTION
At startup, it can take up to three minutes for the HPAC 2.0 to
start supplying warm air.
The HPAC 2.0 will periodically defrost the evaporator coil, if necessary. During the defrosting
phase, the HPAC 2.0 does not supply warm air.
VENTILATION MODE
In this ventilation mode the fan circulates the air in the room. The fan speed can be adjusted
to Low, Medium and High.
To activate ventilation mode, press the ventilation button.
To adjust the fan speed press the fan speed button until the desired speed is
reached.
ATTENTION
The HPAC 2.0 will not cool, heat or remove humidity in this mode.
The HPAC 2.0 will periodically defrost the evaporator coil, if necessary. During the defrosting
phase, the HPAC 2.0 does not supply warm air.

Ephoca HPAC 2.0 Specifications

General

Brand	Ephoca
Model	HPAC 2.0
Category	Heat Pump
Language	English