Installation Guide
40
Adjusting the Position of the Projector
•
Do not make adjustments using the projector's Keystone function. Doing so may result in a reduction in image quality.
•
When setting up multiple projectors using the batch setup function, perform the batch setup before adjusting the
projected image.
s "Batch Setup Function" p.56
a
Press the [Power] button on the remote control or the control panel to turn on the projector
Using the Remote Control Using the Control Panel
Caution
While projecting, do not put your face or hands near the air exhaust vent, and do not place objects
that may become warped or damaged by heat near the vent. Hot air from the air exhaust vent could
cause burns, warping, or accidents to occur.
b
Open the air filter cover, and then adjust the focus using the focus lever
Fine-tune the focus later.
After you finish making adjustments, close the air filter cover.
c
You can change the display language from Language on the Extended menu.
s
Projector's User's Guide - Projector menu
To Next Page
Loading...
Need help?
General
