Appendix
54
h
Press the [ID] button and check the ID setting
The following is displayed.
•
Remote control operation: On is displayed: You can operate the projector currently being operated.
•
Remote control operation: Off is displayed: You cannot operate the projector with the remote control. Repeat
the procedure above to enable remote control operations.
c
•
Each time the projector is turned on, you need to select the projector ID for the projector you
want to operate. When the projector is turned on, the ID set for the remote control is 0.
•
When Projector ID is set to Off, you can operate the projector using the remote control
regardless of the ID setting selected using the remote control.
•
When the remote control ID is set to 0, you can operate all of the projectors regardless of the
projector ID setting.
Adjusting the Image in Multi-Projection
•
Check that projector position adjustment is complete
s"Adjusting the Position of the Projector" p.40
•
If you are concerned about the alignment between images being projected in multi-projection, try performing Arc
Correction.
s"Arc Correction" p.45
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control Using the Control Panel
To Next Page
Loading...
Need help?
General
