Epson EH-TW6000 User Manual

Useful Functions
43
Viewing Area for 3D Images
The projector is equipped with an internal 3D emitter that synchronizes with your 3D Glasses to view 3D
images. This allows you to view 3D images within the range shown in the figure below.
Use the optional External 3D IR emitter if you cannot view the 3D image normally or if you are in a particularly
spacious room.
s p.84
AScreen
BProjector
c Distance from the projector to the screen
Viewing distance when using the projector's built-in 3D emitter
5 m
d Viewing width 4 m
e Viewing angle 60°
f Distance from the screen (viewing is not possible) 0.3 m
c
•
If there are AV devices such as Blu-ray Disc players near the screen, signals from the projector's 3D
emitter may effect operations for the AV devices. Please setup the AV device further away from the
screen.
•
Do not stick anything that will block the signal onto the front of the 3D Glasses.
•
Connect the optional External 3D IR emitter to the External 3D IR port on the rear of the projector with
a LAN cable, and install it at the base of the screen, near the center.
•
The viewing range for the optional External 3D IR emitter is 10 m.
•
The 3D Glasses for this projector utilize 3D Active Shutter Eyewear Technology developed by the
Panasonic Corporation and X6D Ltd.
Warnings Regarding Viewing 3D Images
Note the following important points when viewing 3D images.
Warning
•
Do not disassemble or remodel the 3D Glasses.
This could cause a fire to occur or the images to appear abnormal when viewing, causing you to feel unwell.
•
Do not install the lithium coin batteries with their polarities (plus and minus) inversed.
If the batteries are inversed by mistake, they could explode or leak, causing a fire, injury, or damage the
surroundings. Follow the instructions to install the batteries correctly.
•
Do not leave the batteries or the supplied nose pad within reach of children.
They could be accidentally swallowed. If anything is accidentally swallowed, contact a doctor immediately.

Epson EH-TW6000 Specifications

General

Matrix size	0.61 \
Projection distance	2.95 - 4.8 m
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	- \
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	± 30 °
Aspect ratio	16:9
RS-232 ports	1
Connectivity technology	Wired
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	5000 h
DVI port	No
AC (power) in	Yes
USB connector type	USB Type-A
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	0
Supported video modes	1080p
Supported graphics resolutions	1920 x 1080 (HD 1080)
RMS rated power	20 W
Product color	Black
Market positioning	Home cinema
Power source	AC
AC input voltage	100 - 240 V
Voltage tolerance	10 %
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	274 W
Noise level	- dB
Noise level (economic mode)	24 dB

Weight and Dimensions

Weight	6000 g