Epson EH-TW6000 User Manual

Troubleshooting
70
Problems relating to images
No images appear
Check Remedy
Is the projector turned on?
Press the
button on the remote control or the button
on the control panel.
Is the power cable connected? Connect the power cable.
Are the indicators switched off? Disconnect and then reconnect the projector's power cable.
Check that power is being supplied.
Is an image signal being input?
Check that the connected device is turned on. When Messag-
es is set to On from the configuration menu, image signal mes-
sages are displayed.
s Extended - Display - Messages p.63
Is the image signal format setting correct? When Video is input
If nothing is projected even when Video Signal is set to Auto
from the configuration menu, set the signal that matches the
connected device.
s Extended - Input Signal - Video Sig-
nal p.63
When Component is input
If nothing is projected even when Component is set to Auto
from the configuration menu, set the signal that matches the
connected device.
s Extended - Input Signal - Compo-
nent p.63
Are the configuration menu settings correct?
Reset all of the settings.
s Reset - Reset All p.65
(Only when projecting computer image sig-
nals)
Was the connection made while the power of
the projector or the computer was already
turned on?
If the connection is made while the power is already turned on,
the key (Function key and so on) that changes the computer's
image signal to external output may not work. Turn off the power
for the computer and the projector and then turn it back on
again.
Moving images are not displayed
Check Remedy
(Only when projecting computer image sig-
nals)
Is the computer's image signal set to external
output and to output to the LCD monitor at
the same time?
Depending on the computer's specifications, moving images
may not be displayed when the computer is set to external out-
put and to the LCD monitor output at the same time.
Change it so that the image signal is set to external output only.
For the computer's specifications, see the documentation sup-
plied with the computer.

Epson EH-TW6000 Specifications

General

Matrix size	0.61 \
Projection distance	2.95 - 4.8 m
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	- \
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	± 30 °
Aspect ratio	16:9
RS-232 ports	1
Connectivity technology	Wired
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	5000 h
DVI port	No
AC (power) in	Yes
USB connector type	USB Type-A
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	0
Supported video modes	1080p
Supported graphics resolutions	1920 x 1080 (HD 1080)
RMS rated power	20 W
Product color	Black
Market positioning	Home cinema
Power source	AC
AC input voltage	100 - 240 V
Voltage tolerance	10 %
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	274 W
Noise level	- dB
Noise level (economic mode)	24 dB

Weight and Dimensions

Weight	6000 g