Maintenance
77
Maintenance
Cleaning the Parts
You should clean the projector if it becomes dirty or if the quality of projected images starts to deteriorate.
Warning
Do not use sprays that contain flammable gas to remove dirt and dust from the projector's lens, air filter,
and so on. The projector may catch fire due to the high internal temperature of the lamp.
Cleaning the air filter
Clean the air filter if dust has accumulated on the air filter or when the following message is displayed.
"The projector is overheating. Make sure nothing is blocking the air vent, and clean or replace the air
filter."
Attention
•
If dust collects on the air filter, it can cause the internal temperature of the projector to rise, and this can lead
to problems with operation and shorten the optical engine's service life. It is recommended that you clean
the air filter at least once every three months. Clean them more often than this if using the projector in a
particularly dusty environment.
•
Do not rinse the air filter in water. Do not use detergents or solvents.
•
Lightly brush the air filter to clean it. If it is brushed too strongly, dust will be ground into the air filter and
cannot be removed.
a
Press the button on the remote
control or the control panel to turn off
the power, and then disconnect the
power cable.
b
Remove the air filter cover.
Hook your finger into the tab on the air filter
cover, and pull it straight out.
c
Remove the air filter.
Place your finger in the grove and remove
the air filter.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
