Panel light state Beep pattern Problem
Solution
N On
N K B
N Y B*
N M B*
N C B*
O
The ink cartridge has reached its replacement time.
Replace the ink cartridge. For more information, see “Replacing an
ink cartridge” on page 75.
O
The ink cartridge is not installed.
Install the ink cartridge. For more information, see “Replacing an ink
cartridge” on page 75.
N On
F K B
F Y B*
F M B*
F C B*
-Ink is low.
Obtain a replacement ink cartridge.
F On
F Cover
F K B, F Y B, F M B, F C B
**
F K B, F K B ***
O O O O O
A product maintenance error has occurred.
Contact a qualified service person.
F On
F Cover
F Paper
F Tear Off
F Pause
O O
O O O
A fatal error has occurred.
Turn off the printer and check for a paper jam. If there is a paper jam,
remove the jammed paper, and then turn on the printer.
If the scale is dirty, clean it with a soft cloth. See “Cleaning the Printer”
on page 103.
If the problem persists, turn off the printer, wait several minutes, and
then turn it on again.
* The status of the right black ink light is shown for the GP-M830/GP-M831/GP-M832.
** All of the ink lights flash at the same time (GP-C830/GP-C831/GP-C832).
*** Both of the ink lights flash at the same time (GP-M830/GP-M831/GP-M832).
N = on, F = flashing
O = Ten long beeps
O O O O O = Five sets of five short beeps (twenty-five beeps)
GP-C830/GP-M830/GP-C831/GP-M831/GP-C832/GP-M832 User’s Guide
Troubleshooting 56
To Next Page
Loading...
Need help?
General