20 Displaying and Adjusting the Image
Shutting Down the Projector
This projector incorporates Instant Off technology. To turn it off, you
can press its Ppower button as described below, unplug it, or turn off
a power switch that supplies power to the projector. You don’t have to
wait for the projector to cool off first.
1. To turn off the projector, press the
Ppower
button on the remote
control or projector.
You see a confirmation message.
(If you don’t want to turn it off, press any other button.)
2. Press the Ppower button again. The projection lamp turns off
and you can unplug the power cord.
If you want to turn the projector on again, make sure the orange
Ppower light is not flashing, then press the Ppower button.
3. If you extended the adjustable front foot, press up on the foot
release lever to retract it.
4. Close the A/V Mute slide.
Selecting the Image Source
Selecting the image source lets you switch between images input from
different pieces of connected equipment (such as a computer or DVD
player).
If you don’t see the image you want, press the
Search button on the
remote control or the
Source Search button on the projector until
you see the image you want to project.
note
Lamp life results will vary
depending on mode selected,
environmental conditions,
and usage.
Turn off this product when
not in use to prolong the life
of the projector.
note
To focus and adjust the
image, see page 23. If a
projected image fails to
appear, see page 21 for help.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
