Fine-Tuning the Projector 65
■ Tint (video only)
Adjusts the balance of green to magenta in the image
(available only for component video or NTSC signals).
■ Sharpness
Adjusts the sharpness of the image.
■ Color Adjustment
Adjusts the color values. Select Abs. Color Temp. to adjust
the overall value from 5000 and 10000 °K. Or, select
Red,
Green, Blue
to adjust the saturation values for each color.
(Not available if
sRGB is selected as the Color Mode setting.)
■ Auto Iris
Automatically adjusts the brightness according to the nature
of the image. Improves the depth and detail of dark scenes.
(Only available when
Dynamic or Theatre is selected as the
Color Mode setting.)
Adjusting Signal Settings
Although the projector normally detects and optimizes the input
signal automatically, you can use the Signal menu to make manual
adjustments. In addition to changing the position of the projected
image, you can correct tracking and sync for computer images, or
change the aspect ratio to widescreen format for video images.
1. Press the
Menu button and select the Signal menu.
You see a screen similar to one of those below. (The settings will
be different depending on the source you are projecting from.)
note
You can also use the remote
control’s Auto button to
automatically reset the
projector’s tracking, sync,
resolution, and position
settings. See page 27 for
details.
Computer image Composite video/S-videoComponent video
To Next Page
Loading...
Need help?
General
Weight and Dimensions
