Epson SCARA ROBOT User Manual

Setup & Operation 2. Specifications
30 G6 Rev.21
2.3.3 Ceiling Mounting
Standard-model G6-***SR
Joint #3
(up and down)
Joint #2
(rotating)
Joint #1
(rotating)
Joint #4
(rotating)
Arm #2
Arm #1
Joint #3 and #4
brake release switch
Base
+
−
+
−
+
−
+
−
Shaft
Signature label
(Serial No. of Manipulator)
CE label
Signal cable
Power cable
Fitting (black or blue)*
for ø 4 mm pneumatic tube
User connector
(15-pin D-sub connector)
User connector
(9-pin D-sub connector)
Fitting (white)
for ø 4 mm pneumatic tube
Fitting (white)
for ø 6 mm pneumatic tube
Fitting (black or blue)*
for ø 6 mm pneumatic tube
LED lamp
UR label
* Color differs depending on the shipment time
- The brake release switch affects both Joints #3 and #4. When the brake release switch
is pressed in emergency mode, the brakes for both Joints #3 and #4 are released
simultaneously.
(For G6-**1**, Joint #4 has no brake on it.)
- While the LED lamp is on, the current is being applied to the manipulator.
Performing any work with the power ON is extremely hazardous and it may result in
electric shock and/or improper function of the robot system. Make sure to turn OFF
the controller power before the maintenance work.

NOTE

Epson SCARA ROBOT Specifications

General

Brand	Epson
Model	SCARA ROBOT
Category	Robotics
Language	English