EVS LSM Connect User Manual

LTC Area
The LTC area includes the fields described below:
Field Name Description
TC field (top) Timecode value assigned before the editing action (non-
editable)
TC field (bottom) New timecode value (editable)
Date field (top) Date value assigned before the editing action (non-editable)
Date field (bottom) New date value (editable)
Drop / No Drop
buttons
Radio button to specify whether the TC is drop frame or non-
drop frame
User Area
The same fields as the ones present in the LTC area are displayed, but they apply to the
timecode stored in the User TC table.
Primary TC
This section includes two radio buttons to specify which clip timecode should be
considered as primary TC:
• LTC: Longitudial timecode of the clip
• User: Timecode stored in the User TC table in Multicam.
3.2.6. Pushing Clips to Other EVS Servers
Introduction
It is possible to push selected clip(s) to other EVS servers, either defined as targets in the
Push settings in the Multicam Configuration module, or chosen by the operator from a list
of servers found on the PC LAN.
NOTE
If a default server has been specified in the Multicam Configuration
module, the clips are automatically pushed there and the Select
server on the network dialog box is not displayed.
48 3. Clip Management
EVS Broadcast Equipment SA Issue 2.12.D- April 2020

EVS LSM Connect Specifications

General

Brand	EVS
Model	LSM Connect
Category	Server
Language	English