97
EN
Quick reference
4
1
3
2
5
Fronius International GmbH, www.fronius.com
Keylock
Important! If the keylock is activated, only the
parameter settings can be retrieved, as well
as any assigned “Save“ button provided that
an assigned “Save“ button was selected when
the keylock was enabled.
- press and hold
- press
- release
activate / deactivate:
activated: „CLO | SEd“ display
deactivated: „OP | En“ display
Quick Reference: English
Setting the welding power
Selecting the fi ller metal and
shielding gas
2 T 2-step mode
4 T 4-step mode
S 4 T Special 4-step mode
Selecting the process
Setting the mode
MANUAL MIG/MAG standard manual
SYNERGIC Standard synergic
STICK Manual metal arc welding
Correcting parameters
Important If external system components
are connected, some parameters can be
modifi ed on those components. The power
source control panel is only for display
purposes.
01/2013
Start-up sequence
Follow operating instructions
-
1 5
TransSteel Synergic
SP ... Special Program
- select desired parameter
- set desired parameter
Sheet thickness
Welding current
Wire feed speed
Arc length
correction
Welding voltage
Dynamic
- select desired parameter
- set desired parameter
Real Energy Input
To Next Page
Loading...
Need help?
General
