Fax Procedure
187
Fax
4
Important • To avoid paper jams, use the document glass for folded or wrinkled documents, cut-and-pasted
documents, curled paper, or back carbon paper.
• When Duplex Automatic Document Feeder B1-C is installed, the lightweight paper of 38 - 49 gsm
cannot be scanned 2 sided.
For information on how to fax mixed sized documents, refer to "Mixed Size Originals (Scanning Different Size Documents
Simultaneously)" (P.236).
1 Remove any paper clips and staples before loading document.
2 Load the document face up (when the
document is 2-sided, place the front side up) in
the center of the document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly. If the
indicator does not light, the machine may be
detecting the document on the document
glass. Load the document again.
3 Adjust the document guides to match the size
of the document loaded.
4 Open the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with size 297
x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents.
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
To Next Page
Loading...
Need help?
General
