Output Format
157
Copy
3
1 Specify the orientation of the document in
[Original Orientation] on the [Layout
Adjustment] screen.
2 Place the document slightly away from the top left corner of the document glass, and close
the document glass.
Important • Always use the document glass when copying. You cannot use the document feeder with this
feature.
• Specify the orientation of the original document correctly.
• If the edges of the image are missing, slightly move the card inward on the document glass so that
the whole image can be scanned.
• When the reduced size is specified to copy an ID card, the machine may copy the ID card in a
different orientation from the original orientation depending on the magnification ratio specified.
For information on the copy magnification ratio for ID Card Copy, refer to "5 Tools" > "Common
Service Settings" > "Copy Service Settings" > "Copy Control" > "ID Card Copy - Reduce/Enlarge" in the
Administrator Guide.
For information on how to specify the orientation of a document, refer to "Original Orientation (Specifying the Orientation
of Loaded Documents)" (P.129).
3 Select [ID Card Copy] on the [Output Format]
screen.
4 Select [On].
îš„ Off
Disables ID card copying.
îš„ On
Enables ID card copying.
Original document Original orientation Copied output
Front side
Back side
Front side Back side
To Next Page
Loading...
Need help?
General
