Using the Telephone
753
Appendix
16
1 On the Services Home screen, select [Fax/
Internet Fax].
2 Select the [More Options] tab, and then select
[On-hook (Manual Send/Receive)].
3 Specify the call destination.
The call destination can be specified using the numeric keypad, address numbers, or one-
touch buttons. The Address Book cannot be used.
The call destination can be specified also
with the keyboard displayed on the screen.
Note • To disconnect the call, select [Line Cut].
• If your telephone line is set to touch-tone,
[Tone (:)] does not appear.
• If you want to send tones (or to use the
touch-tone services) while using a pulse line,
select [Tone (:)].
• Some touch-tone services may not be
available even if you set your telephone to send tones.
4 When the call is connected, lift the receiver and
start speaking.
5 After the call is finished, place the receiver back in the cradle.
Important • Make sure that the receiver is placed properly in the cradle. Otherwise, the line remains "busy".
To Next Page
Loading...
Need help?
General
